Ingenious and simple: The new way to connect an AXTON subwoofer

Connecting an AXTON active subwoofer has never been easier

All you need is the ATS-ISOATB cable and the matching vehicle-specific AXTON SPECIFIC adapter cable.

The ATS-ISOATB has been specially developed for the AXTON ATB active subwoofers ATB20A, ATB20RXF and ATB120QBA and can be connected directly to a SPECIFIC cable - a separate connection to the battery is no longer absolutely necessary!

The AXTON configurator on the homepage allows you to select the target vehicle to determine all the required components: The matching vehicle-specific SPECIFIC T wiring harness, the ATS-ISOATB cable and the compatible AXTON active subwoofer models.

The ATS-ISOATB has a total length of 5 m and is protected by a hard-wearing nylon hose. Together with the approx. 1.50 m of the T-cable harness, you can easily reach the subwoofer's installation location in the trunk. The music signal is tapped from the two front speakers.

Note: It is not possible to connect an AXTON DSP amplifier and an ATB subwoofer to a T-cable at the same time.

Notes on vehicle compatibility:

• Seat, Skoda, Audi, Volkswagen:
  When used with VAG 6-channel radios, such as those in current Seat models, the rear and front input signals on the ATS-ISOATB must be swapped, as the signal from the front outputs of such a 6-channel radio only outputs mid and high frequencies.
  The low-frequency signal output on the 52-pin Quadlock connector of such 6-channel radios is via pins 9(+) + 13(-) for front right and 10(+) + 14(-) for front left, instead of the usual pins 1 to 8.
  The latest generation of ATS-ISOATB cables is equipped with Molex connectors, which enable error-free exchange of front/rear signals.