Ingenious and simple: The new way to connect an AXTON subwoofer

Connecting an AXTON active subwoofer has never been easier: all you need is the ATS-ISOATB2 cable and the matching vehicle-specific AXTON SPECIFIC adapter cable. 

The ATS-ISOATB2 has been specially developed for the AXTON ATB active subwoofers ATB120A, ATB20A, ATB20RXF and ATB120QBA and can be connected directly to a SPECIFIC cable - a separate connection to the battery is no longer absolutely necessary!

The AXTON configurator on the homepage allows you to select the target vehicle to determine all the required components: The matching vehicle-specific SPECIFIC T wiring harness, the ATS-ISOATB/ATB2 cable and the compatible AXTON active subwoofer models.

The ATS-ISOATB2 has a total length of 2 m and is protected by a hard-wearing nylon hose. Together with the approx. 1.50 m of the T-cable harness, you can easily reach the installation location of the subwoofer under the seat in the driver's cab, for example. The music signal is tapped from the two front speakers.

Note: It is not possible to connect an AXTON DSP amplifier and an ATB subwoofer to a T-cable at the same time.

Notes on vehicle compatibility:

• Seat, Skoda, Audi, Volkswagen:
  When used with VAG 6-channel radios, such as in current Seat models, the rear input signals must be swapped with the front input signals on the ATS-ISOATB or ATS-ISOATB2, as the signal from the front outputs of such a 6-channel radio only outputs mid and high frequencies.
  The low-frequency signal output of the 52-pin quadlock connector is via pins 9(+) + 13(-) for the front right and 10(+) + 14(-) for the front left, instead of the usual pins 1 to 8.