A 16.5 cm woofer with the proven AXTON CRYSTAX cone is used. The paper cone, which has a warm tone by nature, is additionally reinforced by a special quartz crystal coating. This noticeably improves impulse response and responsiveness. The low frequency range is powerful and controlled, while voices and instruments are reproduced clearly and cleanly – a clear advantage for rhythmic and detailed music.

The measured values of the ATS-TOY160X woofer are also impressive. Precise Klippel analyses confirm a very high symmetry of the force factor (Bl) and the spring stiffness of the oscillating unit (Kms). Even at high deflections, uniform forces act on the voice coil when the diaphragm is deflected in and out. These characteristics are a key prerequisite for authentic, low-distortion, and musically clean reproduction. For use in the rear doors of vehicles, the woofer has been specifically tuned to a resonance frequency (Fs) of 63 Hz and a Qts value of 0.62. This design ensures high power handling,
a natural, confident low-frequency range, and supports balanced, pleasantly relaxed midrange reproduction.

The tweeter features a 19 mm aluminum dome and impresses with its clear brilliance and precise spatial representation. The elastic mounting in a fine fabric surround enables detailed reproduction up to over 22 kHz. Thanks to its vehicle-specific design, the tweeter fits exactly into the original installation position. For additional protection, the connecting cables are equipped with a protective foam band; the plug is precisely matched to the original vehicle connection.

A carefully designed crossover is essential for harmonious interaction between the tweeter and woofer. In the ATS-TOY160X, this task is performed by a sophisticated 12/12 dB crossover for the low and high frequency ranges. It ensures that both drivers work together optimally to produce a stable, balanced sound image.

A specially developed sound preset is available for the ATS-TOY160X in the apps for the AXTON DSP amplifiers A544DSP and A594DSP, currently for use in the Toyota C-HR (other models are planned). This preset uses runtime correction and extensive equalizer settings to optimally tune the sound in the vehicle. The presets can be accessed free of charge via the respective DSP app.

Frequency response

• 55 Hz - 22 kHz

Rated load capacity

• 80 W RMS
• 120 W Max

Impedance

• 3 Ohm

Efficiency

• 90 dB / 1W/ 1m

Main features

• Tweeter
  • 25 mm aluminum dome with fabric surround
  • Ferrofluid-cooled voice coil
  • Vehicle-specific connections
  • 12 dB/oct. tweeter onboard crossover
• Woofer
  • 16.5 cm bass-midrange driver
  • Custom-fit loudspeaker design, vehicle-specific connections
  • AXTON CRYSTAX membrane
  • 12 dB/oct. woofer onboard crossover
  • 25 mm voice coil
  • Ferrite magnet
  • NOMEX centering spider
  • Rubber surround

Scope of delivery

• 2x woofer
• 2x AXTON Specific metal emblem sticker
• 1x operating instructions